Sliding Gate 'T1' Maintenance Schedule

For more information on the Type 1 Sliding Gate CLICK HERE

Scope of Works

• Inspect drive cog for wear and lubricate.

• Inspect, open and close limit switches and adjust when necessary.

• Inspect drive chain or linkage for wear and adjust tension when necessary.

• Check safety edges for correct position and operation.

• Check control unit, and report any fault found.

• Inspect all bearings and lubricate as required.

• Check drive motor, etc. for correct operation.

• Check all electrical terminations and tighten as required.

• Check manual operation.

• Ensure plinth holding down bolts, nuts are tight.

• Check general condition and report on it.

• Check induction loops if applicable.

*NB     All new parts fitted are chargeable at the discretion of Newgate (Newark) Ltd.